Quick Usage Guide
Thank you for choosing a Vivo product. The Vivo is a pressure-
supported and pressure-controlled ventilator for homecare.
This Quick Reference Guide allows you to easily start up your
treatment.
Switching On and Off
Using the Menu
Using the Memory Card
Humidifier
Wake Up Alarm
Cleaning and Replacing the Patient Air Filter
Washable Filter (grey colour)
Replace the washable filter at least once a year. Wash the filter
at least once a week.
Disposable Filter (white colour)
Replace the filter at least every 4th week, or more often when
used in high pollution or pollen-rich environments.
This is not a complete guide for the Vivo. See your
manual for complete instructions.
Make sure the mains supply is
connected and the On/Off button
is switched on.
Turn on the Vivo by pressing the
Start/Stop button for 2 seconds.
Turn off the Vivo:
1.
Press and hold the Start/Stop
button.
2.
Release the Start/Stop but-
ton.
3.
Press the Start/Stop button
again.
Use the four navigation buttons
and the up, down, “+” and “-”
buttons in order to navigate the
Vivo menu.
The Vivo can only copy and transfer data to the
memory card in standby mode (not operating).
1.
Insert the memory card in the
memory card slot on the side
of the Vivo. Make sure the
memory card is properly
inserted.
2.
Navigate to the “Memory
card” page under the “Oth-
ers” section.
3.
Select the desired operation
and wait while the ventilator
loads or saves to the memory
card.
1.
Navigate to the “Humidity“
screen.
2.
Use the navigation buttons to
alter the humidity settings.
Use the navigation buttons to go
to the “Wake Up Alarm“ screen
and to turn the wake up alarm on.
Press the Start/Stop button to turn
off the alarm signal when the alarm
is going off.
The patient air filter is located in
the filter cassette at the rear of the
ventilator.
There are two types of filters:
