Step B (Wiring and Final installation)
REMOVE THE PLASTIC COVER OF HINGE BEFORE YOU INSTALL LCD MONITOR. With
the vehicle powered off, mount the monitor into place using the pre-drilled holes (Prior to
installation, always check the clearance of the screw lengths to ensure that you do not puncture
the roof).
With the Metal Bracket securely placed, drill small holes to accommodate the wiring cable so
that the Din cable, male end is at the area where the monitor will be installed. Ideally, the hole
for the cable should be drilled in the side areas of the mounting bracket. NOTE: The wires
are fed through both sides of the monitor. The other end of the cables should be run to the
area in which you will have your source unit installed (ex. DVD player).
BEFORE DRILLING ANY HOLES, ALIGN THE PLATE AND MONITOR TO ENSURE
PROPER PLACEMENT
.
There are two sets of RCA cables (Yellow-Video Signal, White-Audio Left, Red-Audio Right).
This is for A/V Input and output. POWER- Connect the red wire to a fused source that shows +12volts
when the key is in the accessory position. Attach the black wire to any metal part of the vehicle that is
ground (-12volts).
