28
INSTALLATION
PROFESSIONAL INSTALLATION RECOMMENDED!
Key Installation Notes!
o
To avoid short circuit in the electrical system, ensure that the negative battery
cable is disconnected before installation.
o
To prevent short circuit in the wiring and damaging to this unit, secure all wirings
with cable clamp or adhesive tape. Route the wirings in a secured, out of heating
place without touching any moving parts such as gear shift, handbrake, and seat
rails to prevent the wiring insulation being melted / wore off.
o
Never pass the yellow power cord through the installation hole into the engine
compartment and connect to the car battery. Otherwise, a high possibility of
serious short circuit to the electrical system may be occurred.
o
Replacing a new fuse with 15A rating when the old one is broken, using no fuse or
fuse with improper rating may cause damage to this unit or even fires. If a proper
fuse is installed and electrical problems still occur, please contact with any
professional car shops for inquiry.
o
DO NOT
connect other equipment with the car battery to avoid battery
overheating.
o
Please make sure all the wiring connections & the cables of the Speakers are well
insulated. Otherwise, this unit may be damaged by short circuit.
o
If there is no ACC available, please connect ACC lead to the power supply with a
switch.
o
If an external power amplifier is connected, please don't connect P.CONT lead to
the power lead of the external power amplifier otherwise an electric spark or
other damage may be resulted.
o
Never ground the speaker output to prevent the damage to the built-‐in power
amplifier.
o
The minimum rating of the speakers connected to this unit is 50W with 4 to 8Ω
impedance.
