BRAVILOR BONAMAT Chiller, Operating Instructions Manual

Page: 15 / 22

GB
version E Copyright Bravilor Bonamat B.V.
6
1.0
5. MAINTENANCE BY SPECIALLY
AUTORIZED PERSONNEL
READ! (700.403.347)
5.1 General cleaning
D
Clean the exterior of the device with a damp
cloth (if necessary, use a non − abrasive
cleaning agent).
D
Use a vacuum Cleaner to clean the grille at the
rear of the device.
5.2 Flushing the cold − water system
Flush the cold − water system with clean water if
you have not used it to draw off water for one to
two weeks:
1. Deactivate the device by removing the plug
from the socket.
2. Use the draw − off tap to draw off the contents
(approx. 2 litres) of the cold − water reservoir.
3. Reactivate the device by putting the plug into
the socket.
4. Now wait approx. 30 minutes until the display
stops flashing and the water is again at the
set temperature.
The device is now ready for use.
5.3 Cleaning the cold − water reservoir and replacing the
water filter
The cold − water reservoir is to be cleaned and the
water filter (B.) at the rear of the machine is to be
replaced (see fig. 5 ) when:
− when the device has not been used for a
relatively long period of time and the water
that is drawn off has an unusual taste.
− at least every six months or when the
filter − replacement indication (fig. 1 , C1) is
flashing
5.3.1 Cleaning procedure for
the cold − water reservoir
D Replace filter, see fig. 5 .
A. = cover
B. = filter
C. = reservoir
D. = de − aeration button (red)
E. = key
D Before cleaning make sure the following items
are available:
− bottle of Hadex (25 ml)
− new water filter and also supplied gloves
n Before use carefully read the instructions of the
drinking − water disinfectant to be used first. For
example, Hadex (sodium hypochlorite).
1. Pull the plug from the socket.
2. Completely drain the content of the
cold − water reservoir. Throw this water away.
3. Unscrew the container (C.) of the water filter
from the cover using the also supplied key (E.).
4. Empty the container.
5. Clean the container with hot water, a normal
cleaning agent and a brush.
6. Thoroughly rinse the container with hot water.
7. Pull the filter (B.) out of the cover (A.) and
throw the filter (B.) away.
8. Thoroughly clean the cover on the inside with
a piece of paper.
9. Now wash your hands thoroughly with hot
water and soap.
10. Put the also supplied gloves on.
11. Fill the container (C.) with 600 ml tepid water
( $ 20 C) and also poor the content of the
bottle of Hadex (25 ml) into the container.
12. Screw the full container (without filter!) in the
machine again.
13. Insert the plug in the power socket.
− The machine will start filling.
14. Wait for about 10 minutes.
15. After that tap off a cup of water to have the
cleaning agent also work inside the tap.
16. Wait until the temperature has dropped to 6 C.
17. Pull the plug out of the socket again.