12 |
BRSG105K REV A
SAFETY & OPERATION
QUICK START & TROUBLESHOOTING
QUICK START SETUP
•
Add 10W30 oil to the engine
•
Add Gas
•
If pivot grinding side to side, pin one wheel into pivot brake hole, other wheel free turning
•
Insert tether into switch located on handle
•
Half throttle (choke optional for cold starts)
•
Tip the unit back with the cutters off the ground
•
Pull start the engine
STUMP GRINDING
•
Engine set on highest speed
•
Hold tight on bow handle with both hands
•
For plunge cutting, lower cutters into top of stump, grind to the depth of the cutters
•
Raise cutters up and move over for next cut, repeat
•
Pivot cutters from side to side to face off remainder of the stump
TROUBLESHOOTING
• ENGINE WON’T START
•
Ensure tether is instered into switch located on handle properly. Check engine oil and
gas level. Ensure red “slap” on/off switch, mounted on handlebar is spring loaded in the
up/run position.
•
Unplug wire from On/Off switch located at the base of the handle (Step 5 of Assy Instruc-
tions - Pg 8) - if engine starts, replace the On/Off switch
•
Follow your engine manual for further troubleshooting
• UNIT VIBRATES
•
Check your cutters for missing or loose teeth
•
Check your cutter wheel pillar bearing mounting bolts
•
Check all belts and pulleys
ENGLISH