Braun Multiquick 3 WK 300, User Manual

Page: 5 / 6

5
Thank you for purchasing the Braun Multiquick,
we hope that the design and the rapid
boil feature give you many years of pleasure.
Before first use, read the use instructions care-
fully and keep them for future reference.
Important
• Make sure that your voltage corresponds to the
voltage printed on the bottom of the kettle. The
kettle may only be operated on the base (g)
supplied.
WK 300: base type 3221
WK 500: base type 3222
• This appliance is intended for household use
only.
• This appliance is not intended for use by child-
ren or persons with reduced physical, sensory
or mental capabilities, unless they are given
supervision by a person responsible for their
safety. In general, we recommend that you keep
the appliance out of reach of children. Children
should be supervised to ensure that they do not
play with the appliance.
• Only use the kettle to heat water.
• Only operate the kettle on a dry, flat and fixed
surface.
• Never let the cord hang down from the worktop.
The cord length may be reduced by winding it
up with the cord storage facility.
• The base, the kettle or the cord must never get
in contact with hot surfaces (e. g. stove plates).
• In case the empty kettle is switched on acci-
dentally, the overheating protection will cut it
off automatically. In this case, allow the kettle
10 minutes to cool down before filling it with
water.
• Caution: Do not overfill the kettle !
Water could boil over and cause scalding.
• Do not open the lid while water is boiling.
• During operation, the kettle will get hot. There-
fore only use the handle to carry it. Always
hold the kettle in an upright position, to avoid
boiling water come out.
• Check the cord regularly for possible damage.
• If the appliance shows any defect, stop using it
and take it to a Braun Service Centre for repair.
Faulty or unqualified repair work may cause
accidents or injury to the user.
• Braun electric appliances meet applicable
safety standards.
Model WK 500 only:
• Make sure not to operate too many other elec-
tric appliances when using the kettle.
• Socket fuse at least: 16 A
Description
a Scale filter (removable)
b Lid
c Lid release button
d On/off
switch
e Water level indicator
f Pilot
light
g Base with cord storage
• Max. capacity: 1.7 l water
Before first use
Before using the kettle for the first time, fill it
up twice with water to the maximum level and
bring it to boil. Empty the kettle after boiling each
time.
After repeatedly boiling water it is normal that
some condensation may have formed on the
base of the water kettle.
If this happens, just wipe dry with a cloth.
Setting into operation
1a Fill the kettle through the spout with the lid
closed, or
1b press the lid release button (c), open the lid, fill
with water and close the lid again (the kettle
will not work with the lid open).
2 Place the kettle on the dry base and plug in
the base.
3 Press the on/off switch (d), the pilot light will
come on (do not open the lid when the kettle
is switched on).
4 When the water has boiled, the kettle auto-
matically switches off.
You may also stop the heating procedure at
any time by pressing the on/off switch (d).
Automatic cut-off feature
The kettle switches off when ...
–
the water has boiled,
– it contains no water
(in case of accidental switching on),
– the lid is opened,
– it is taken off the base.
If the scale filter is not installed, the automatic
cut-off will be delayed.
Cleaning
Before cleaning, unplug the base.
Kettle or base must never be immersed in water.
Clean the outside of the kettle with a damp cloth,
English
99327794_WK500-300_Korea Seite 5 Freitag, 5. November 2010 11:22 11