Braun Gilette Venus Naked Skin 6028 Series, User Manual

Page: 17 / 53

BEFORE TREAT RESULTS
5
1
3
2
4
7
6
8
3
2
1
Skin Tone Sensor
1.
Sensor Button
2. Setting Lights
3. Bulb Life Indicator
4. Sensor Window
on the back side
4
The Venus Naked Skin ® device is powered by Intense Pulsed Light (IPL), derived
from professional light technology that is used by dermatologists/professionals
worldwide for the treatment of unwanted hair.
The Venus Naked Skin
®
System includes:
1. Base unit
2. Handset (connected to base unit)
3. Detachable Skin Tone Sensor
(see page 31 for details on the Skin Tone Sensor)
4. Activation button
5. Power supply
6. Treatment window in the front of handset
7. ™ Activating Gel
8. User Guide
Introduction to Gillette Venus Naked Skin ®
The Venus Naked Skin
®
Intense Pulsed Light (IPL) system is derived from professional
IPL technology and helps break the cycle of hair regrowth. The light energy is
transferred through the
™
Activating Gel to target the melanin in dark hair, helping to
put the hair to sleep.
Venus Naked Skin ® comes with ™ Activating Gel. This is a clear, water-based
gel that enables the light to transfer to the hair during treatment to optimize
effectiveness.
Do not use Venus Naked Skin
®
if you do not have Activating Gel. The gel is available
for purchase at your retailer.
™
Activating Gel
How It Works
The treatment area should be clean,
hair-free and dry.
1. Remove any visible hair before using
Venus Naked Skin ® . Removal of hair
ensures the light reaches the hair
follicle during treatment.
2. Cleanse the treatment area and
pat dry.
You could experience noticeable hair reduction after 6 treatments and long lasting hair
removal after 6 – 12 treatments. Continue to treat once every two months to maintain
results and to enjoy continuously smooth, beautiful skin.
What to Expect
How to Use
Getting Started
Check Your Skin Tone
USING THE SKIN TONE SENSOR
Venus Naked Skin ® has an integrated
Skin Tone Sensor designed to assist you
in choosing the appropriate skin tone
setting for your skin.
To measure your skin:
1. Remove the Skin Tone Sensor from
the base unit. The RED Skin Tone
Sensor light will go out to indicate it
is ready.
2. Place the sensor window of the Skin
Tone Sensor to the clean, dry area of
skin you wish to treat.
For comfort and safety, always
choose the darkest skin, e.g., for leg,
test the outside of the lower leg; for
arms, use the back of the hand.
For the face, test the cheek or upper
lip area.
Setup
To power on the device:
1. Place the device unit on a firm
surface. The handset should be
securely placed in its cradle on the
base unit.
2. Plug the power supply into an
electrical outlet. The Skin Tone
Sensor button will illuminate RED to
indicate STANDBY mode. A skin tone
reading is required to begin.
HOW TO USE
HOW TO USE
31 30