Braun FLEX XPII 5790, Manual

Page: 31 / 36

31
Manual cleaning
Remove the shaver foil (shaver head must be
in central position) and, using the brush, clean
the cutter block and the inner area of the
shaver head. Do not clean the shaver foil with
the brush.
When cleaning the shaver under running
water, make sure it is completely dry before
putting it into the Clean&Charge.
Replacing the shaving parts
The shaver foil and cutter block are precision
parts that, in time, are subject to wear.
Replace your foil frame and cutter block every
18 months and get a 25% better shave.*
(Shaver foil and cutter block: part no. F/C505,
available at your dealer or Braun Service
Centres).
* (Overall evaluation from Braun users
comparing their shave with new parts and
those used for 18 months.)
Preserving the batteries
In order to maintain the optimum capacity of
the rechargeable batteries, the shaver has to
be fully discharged (by shaving) every
6 months approximately. During this time
clean only manually and not in the
Clean&Charge. Then recharge the shaver to
full capacity again.
Do not expose the shaver to temperatures of
more than 50 °C for longer periods of time.
Environmental notice
This appliance is provided with nickel-
cadmium batteries. To protect the environ-
ment, do not dispose of this appliance in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or appropriate collection sites.
However, if you prefer to dispose of the
product yourself, remove the batteries as
shown.
Caution: Opening the housing will destroy
the appliance and invalidate the guarantee.
Subject to change without notice.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to the
Low Voltage Regulation (73/23 EEC).
Electric specifications see type plate on the
product‘s housing.
Cd
FlexXP_5795/90_Japan Seite 31 Donnerstag, 12. Dezember 2002 10:27 10