9
The appliance emits a loud
noise associated with vibra-
tions (subtle pumping sound is
normal).
A new anti-limescale filter car-
tridge has just been installed.
Continue to press the steam button
until the loud noise stops and steam
comes out of the soleplate.
The water tank is empty.
Refill the water tank and press the
steam button until the loud noise
stops and steam comes out of the
soleplate.
The anti-limescale filter cartridge
is not in place.
Place the anti-limescale filter car-
tridge in the compartment.
The anti-limescale filter cartridge
is damaged or shows cracks.
Inspect the anti-limescale filter car-
tridge thoroughly. If you see any
sign of damage or cracks, replace
the anti-limescale filter cartridge
with a new one.
The first time the appliance is
turned on, you notice smoke /
smell.
Some parts have been treated
with sealer/lubricant which
evaporates the first time the iron
heats up.
This is normal and will stop when
you have used the iron a few times.
If the smoke/smell is still present
after turning off the appliance, con-
tact an authorised Braun Customer
Service.
There is too much steam
coming out of the iron.
Mode turbo is on.
Activate the iCare or eco mode by
pressing the mode button.
Water (dirty) droplets and
impurities come out of the
soleplate.
After the anti-limescale filter car-
tridge replacement, remaining
water may drip out of the sole-
plate.
Take the iron out of the base and
position it horizontally on a thick
towel or cloth. Press the steam
button and the reset button at the
same time until the Temperature
Control LED on the iron starts
flashing. Release the 2 buttons and
wipe the soleplate dry with a cloth.
Watch out – the soleplate is hot.
All LEDs are flashing.
System error.
Unplug the system, plug in again. If
the problem is still present turn the
appliance off immediately and con-
tact an authorised Braun Customer
Service.
5712812211_IS_2043_2044_CN.indd 9
5712812211_IS_2043_2044_CN.indd 9
21.02.19 10:29
21.02.19 10:29
