Braun A5S1-n Series, Manual

Page: 7 / 36

A5S1-n-Manual_EN_Rev02 2021_JAN_19 Page 7 of 36
Figure 3: Information on profile size
D
W
T
Profile size of a
grooved wheel
D = min. 3 mm
W = min. 3 mm
T = min. 5 mm
1.4.2.2 Recommended Air Gap
The recommended air gap between the sensor front surface and the rotating part must be
observed. It increases with the size of the profile: For cams or milled grooves with their width,
distance and depth, for a gear with its module (= diameter / number of teeth). The field between
grooves or cams must be at least as large as the specified width (W), the depth D = at least 3
mm. Thickness of a gear or length (T) of a milled recess of at least 5 mm (plus a possible axial
displacement).
The guideline values given below for the profile size (D / W / T) of a rotor are the minimum
dimensions, they may be exceeded in any direction. However, the maximum permissible air gap
between the sensor and the pole wheel will not increase.
Air gap in dependency of profile size
A5S1DS0 … -n
A5S1DD0 … -n
A5S1DS3 … -n and DS4 … -n
A5S1DD3 … -n and DD4 … -n
Module of a
gear wheel
Diametrical Pitch
approx.
min. width W of a
groove wheel
Recommended
air gap
Recommended
air gap
m1 25.40 mm 3 mm 0.5 – 0.8 mm --
m1.5 16.93 mm 3 mm 0.5 – 1.0 mm --
m2 12.70 mm 3 mm 0.8 – 1.5 mm 0.3 – 0.8 mm
m3 8.47 mm 3 mm 0.8 – 2.0 mm 0.3 – 1.2 mm
m4 6.35 mm 3 mm 1.0 – 2.5 mm 0.5 – 1.5 mm
1.4.3 Maximum fastening torques / wrench sizes / thickness of BRAUN nuts
Nut
Maximum
fastening torque
wrench size
thickness
(+/- 0.5 mm)
M12 x 1 12 Nm WS 19 6 mm
M14 x 1 25 Nm WS 22 4 mm
M14 x 1.5 25 Nm WS 22 7 mm
3/4“ -16 25 Nm WS 28 10 mm
M16 x 1 35 Nm WS 24 8 mm
M18 x 1 50 Nm WS 26 9 mm
3/4“ -20 50 Nm WS 24 6 mm
M18 x 1.5 50 Nm WS 26 9 mm
5/8“ -18 50 Nm WS 24 10 mm
M22 x 1 75 Nm WS 30 6 mm