7
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
p
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
p
, connect the
station power socket
6
to an electrical outlet.
• Press the lift button
2
to open the housing.
• Hold the cleaning cartridge
7
down on a fl at,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
1
will show how much
fl uid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts
u
on the back of the
shaver will align with the contacts
3
in the
cleaning station).
Important: The shaver needs to be dry and
free from any foam or soap residue!
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators
5
will
light up:
shaver is clean
short economical cleaning required
normal level of cleaning required
high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
start button
4
.
For best shaving results, we
recommend cleaning after each shave.
fast clean
fast clean
fast clean
2
1
trimmer
Series 7
96183057_799cc-6_NA_S4-42.indd 7
96183057_799cc-6_NA_S4-42.indd 7
07.11.12 13:23
07.11.12 13:23