Braun 12830010, Manual

Page: 9 / 20

9
c. Place the appliance on the edge of the sink and
open the transparent cover (10).
d. Turn the closure (11) anticlockwise to open it.
e. Let the water fl ow into the sink.
f. Turn the appliance slightly in an inclined position
to empty the boiler completely.
g. When no more water comes out of the appliance
screw the closure to close the boiler and close
the transparent cover.
h. After having fi nished the descaling procedure,
plug in and switch on.
i. Press the reset button (4) for 5 seconds until the
LED (3) turns off .
If the appliance is switched off without descaling
the LED (3) will start to fl ash again when it is next
switched on.
Note: Because of the diff erent water composition
by using an installed in-house permanent descaler,
it is recommended to descale the system after
every 4 complete refi lls or at least once per month.
Please note that in this case the icon for descaling
will not automatically start fl ashing.
(G) Care and Cleaning
•
Before cleaning, always make sure that the
appliance is switched off , unplugged and has
cooled down completely.
•
To clean the soleplate it is suggested to use a
damp cloth.
•
To clean the soft material on the handle and the
high glossy surface use a damp cloth only.
•
Never use chemicals, vinegar or scouring pads
(eg. sponges with coarse nylon fabrics etc).
Troubleshooting guide
PROBLEM CAUSE REMEDY
The appliance does not
switch on. The appliance is not plugged
into a mains socket.
Make sure the appliance is correctly
connected and press the On/Off button.
Steam comes out under the
base unit. The «max» pressure safety
system has opened.
Turn the appliance off immediately and
contact an authorised Braun Customer
Service.
There are some water drops
from the holes in the bottom
of the soleplate.
Water has condensed inside the
tubes because steam is being
used for the fi rst time, or has not
been used for some time. Press the steam button several times
away from the ironing board. This will
eliminate cold water from the steam
circuit.
Brown coloured fl uid leaks
from the soleplate.
Chemical water softeners or
additives have been poured into
the water tank boiler. Never pour products into the water
tank. Clean the sole plate with a damp
cloth and rinse the boiler.
The fi rst time the appliance
is turned on, you notice
smoke / smell.
Some parts have been treated
with sealer / lubricant which
evaporates the fi rst time the iron
heats up.
This is normal and it will stop when you
have used the iron a few times.
If the smoke/smell is still present after
turning off the appliance, contact an
authorised Braun Customer Service.
The appliance emits an
intermittent noise associated
with vibrations.
Water is being pumped into the
boiler.
This is normal and no action is needed.
Water tank is empty.
Refi ll the water tank and press the reset
button.
The closure is diffi cult to
unscrew.
Lime scale has made the
closure diffi
cult to open.
Turn the cap forcefully. To avoid the
problem, rinse system frequently.
All LEDs are fl ashing. System error
Unplug the system, plug in again and
press the On / Off button. If this problem
is still present, turn the appliance off
immediately and contact an authorised
Braun Customer Service.
5712812401_IS_5145_5155_CN.indd 9 29.05.20 11:30