Brandt BWF612WWE, User Manual

Page: 10 / 27

INSTALLATION
10
Connecting the Water Supply Hose
1. To prevent leakage from the connection
joints, ensure the rubber washer seals are
fitted to each end of the water supply
hose. Do not use without the seals in
place.
2. Fit the straight end of the water supply
hose to the cold water tap.
3. Connect the angled end of the white
headed hose to the water inlet valve on
the machine. Hand tighten the plastic
parts of the connections. If you are
unsure, please call a qualified plumber for
safer connections.
4. Open the tap slowly and check that
there are no leaks around the connection
joints.
U-Shape Holder
Draining to a wash-basin Draining to a drain hose
Water Drain Hose
Points to remember:
• Don’t twist, pull out or bend the drain hose.
• Your washing machine should be no more than 85cm from the drain outlet.
• The water drain hose should be mounted at a height of minimum 60 cm, maximum 100
cm from the ground.
Draining to a sink or wash-basin
• Secure the drain hose in position, so it can’t drop out of the basin.
• Don’t block the basin’s drain outlet, and make sure that the drainage through it is
sufficient to prevent overflowing.
• Don’t let the tip of the drain hose dip into the drained water, as this can cause the water
to flow back into the washing machine.
3/4”
3/4”
min. 10 mm
min. 10 mm
Plastic joint
L712WM_S13_IB_RC_Final131120.indd 10 20/11/2013 3:48 PM