Brandt BWD89H2DA, User Manual

Page: 11 / 13

19 20
MAINTENANCE
As necessary, approx. once every 2 months,
remove the fluff from the heat exchanger
using the sponge or soft brush.
When doing this, please use gloves.
•
•
Clean heat exchanger
MAINTENANCE
extension of drying time and energy consumption.
• Do disconnect the power cord before cleaning!
• Do not operate the dryer without the filter!
• Clean the filter after each use to prevent lint accumulation inside the dryer.
• The fluff accumulated on the filter will block the air circulation, which will cause the
Note!
first dampened.
• TThe fluff can be removed more easily if it is
Note!
Trouble Shooting
If you cannot deal with the fault by yourself and need help:
• Press the
【
On/Off
】
button
.
• Pull out the mains plug and call the service
.
Warning! ！
“ ” E32
“ ” E33
Dispiay
Reason Solutions
Please contact your local
problem persists.
Humidity sensor error
Temperature sensor error
service center if the
• Only authorised technicans can carry out repairs.
• Before you call service,
fault yourself or if you have followed the user instructions.
• A technician will charge you for advice, even during the warranty period.
please check if you have dealt with the
Warning!
！
• Clean lint filter and .
• Empty container.
• Check drain hose.
• Dryer installation place is too restricted.
• Clean the moisture sensors.
• Keep the Air inlet clean
.
• Use higher drying intensity level programme or
time programme.
heat exchanger
• “ ”is lighting
•“ ”is ing light
Problem
Solution
•Display does not
on
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected programme .
• Press the
【
On/Off
】
button.
• Empty water container.
• If the light is still on, please call the service.
• Clean heat exchanger.
• Clear lint filter.
•Dryer does not start
• the door has closed.
• Check the programme has set.
• Check the start button has selected.
Check the
•Degree of dryness was
reached or drying time too
long
not