12
English
Repeat the above step for the other buttons. The device is now ready to be used.
The status LED flashes once a signal is emitted when the button is pressed.
7. Duplicating the rolling code
First press the button A. When the LED flashes, press the B button quickly three
times and the LED stops glowing. Keep A button pressed, until the next step is
completed.
Place the original remote control next to the remote control to be cloned and
keep button A of the original remote control pressed until the LED on the clone
remote starts flashing rapidly. This indicates that all the buttons have been suc
-
cessfully duplicated. Release both the buttons.
8. Recovering the last deleted code
If you accidentally delete the code, you can recover it again by pressing and
holding the two buttons "C" and "D" simultaneously on the remote control. After
10 seconds, the LED flashes twice and goes off. This indicates that the old code
has been recovered.
Note: For remote controls with fixed code and learning code, the duplicator works
after duplication.
However, for the rolling code make mentioned above, follow the original user
manual to program the duplicator after duplicating it on the receiver.
9. Replacing the battery
Unscrew the battery cover using an appropriate screwdriver. Remove the empty
battery and replace it with a 12V A27 battery. Always pay attention to the correct
polarity of the battery.
10. Safety instructions and disclaimer
Never try to open the device to carry out repairs or modifications. Avoid contact
with the mains voltage. Do not short-circuit the product. The device is not approved
