Brandson Equipment 20200410FZ012, User Manual

Page: 15 / 48

15
English
Note: If you have selected the 12-hour display, the "PM" LED is displayed at the
corresponding times.
7. Setting the alarm
Press the "AL" button. The alarm time 1 is shown on the display and the hour
display flashes. To do this, once again press the "UP" and "DOWN" buttons to set
the alarm. Confirm your entry using the "AL" button. The setting cycle is as follows:
1. Hour
2. Minute
3. Alarm function (OFF rd, bu; OFF = alarm switched off; rd = Radio alarm; bu =
Beep alarm)
After Alarm 1, you can set the Alarm time 2. Proceed with the setting as described
above.
8. Activating the alarm
If you have not selected the alarm function "OFF" in the alarm settings, then the
respective alarm is active. When the desired alarm is activated or deactivated, this
is shown on the display.
When Alarm 1 or Alarm 2 is set off, the corresponding LED flashes in the display.
Caution! The alarm will be completely switched off if you press the "Radio On/Off"
button or the "AL" button. The alarm will go off again on the next day.
Note: When the second alarm time is activated during the first alarm time or the
alarm time 1 in snooze mode, then the second alarm time overrides the first one.
9. Snooze function
As soon as the alarm goes off, press the "SNOOZE/DIMMER" button to defer the
alarm to a later time. The alarm sound or radio alarm then does off again later.
The duration of the snooze function is set using the time setting. The default value
is 9 minutes. However, you can select between 5 and 60 minutes.