INSTALLATION INSTRUCTIONS
9002-8853 instructions 01-25-2017.docx
Page
3
of
5
GS
Mounting camera BELOW the fairlead:
1.
Lay camera face down on a bench or table with something to protect the face of the camera. Remove
the (4) 3mm Allen bolts on the side of the camera mount.
2.
Pull the bracket off the mount and rotate 180º and insert the Allen bolts back in, do not tighten all the
way until installed and adjusted.
3.
On the inside on the camera mount, loosen the (2) 2.5 mm Allen screws to turn the front camera 180º.
(There is a sticker inside the camera housing, on top of the camera. The sticker shows the top/up side of
the camera.)
4.
Tighten the (2) Allen screws back tight. Apply Z-tech the the back of the camera where the Allen screws
are and on the insides on the camera housing.
5.
Remove the fairlead from your front winch assembly and/or bumper.
6.
Position the front camera bracket so that its mounting holes line up with the mounting holes on your
fairlead. With the camera over the top of the fairlead.
7.
Before the bolts go back into the fairlead and camera mounting plate, apply Z-tech to the bolts holes and
anywhere on the back or side if any adjustments get made.(Later in install instructions.)
8.
Reattach the fairlead and front camera bracket to your front winch assembly and/or bumper with the
camera on top of fairlead.
