INSTALLATION INSTRUCTIONS
7637 Instructions 6-9-14.docx
Page 3 of 4
Step 10: Plug the vehicles 32-pin radio
connector into the female 32-pin connector
of supplied Display Harness.
Step 11: Connect the trigger wire on
provided Display Harness to vehicles 12v
Reverse power.
Using a vehicle specific service
guide/wiring diagram and a multi-meter locate and
verify 12v Reverse power source.
Step 12: Plug the male 32-pin connector of
supplied Display Harness into the radio.
Step 13: Connect Power Harness male RCA
connector to Display Harness female RCA
connector.
Step 14:
Using a vehicle specific service
guide/wiring diagram and a multi-meter
verify 12v Ignition power source.
Red wire
of power harness connects to 12v+ Ignition
power and Black wire of power harness to
Black chassis ground nut or wire.
RECOMMENDED
:
Solder wires and cover with Heat
Shrink Tubing or use T-taps as an optional
connection method.
Step 15: Connect Chassis Harness to supplied
Power Harness RCA and power plugs.
Step 16: Use Wire Ties or Electrical Tape to
secure Chassis Harness and Jumper Harness
RCA and power connections
.
Step 17
:
Coil any excess
Chassis Harness and
secure it and the Jumper Harness to existing
vehicle wiring with Wire Ties or Electrical
Tape.
Step 18: Reinstall radio display and
inspect
that all connections are proper and secure.
Step 19: Test system.
Close trunk or liftgate and
clear all removed items from around the vehicle
before starting the vehicle. Next, shift into Reverse
and check radio display for the camera image.
Step 20: (If necessary) Adjust camera aim.
Reposition camera to the desired viewing angle.
Step 21: Reassemble vehicle
. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
