INSTALLATION INSTRUCTIONS
AVMS-3701v3 Instructions 11-27-17.doc
Page 9 of 9
different types of factory and aftermarket
bumpers available for the Jeep Wrangler.
3.
The camera needs to have a clear view of the
road below and out in front of the vehicle.
4.
You can use the plastic mount provided for the
front camera. Or make your own.
5.
The white sticker on the camera is up.
6.
Route the camera harness into the vehicles
interior through the factory grommet in the
firewall. Run the harness over behind the glove
box area.
2 BUTTON KEYPAD LOCATION
1.
Place the keypad somewhere easy to get to like
in front of the center console.
2.
Run the keypad harness over to the glove box
area.
3.
For factory display radios, the power button on
the key pad turns on the system and the
interface to show the image on the factory
display below 7 MPH.
4.
For aftermarket radios or displays the power
button will turn on the video output labeled
CVBS. The video output labeled CVBS RV is on
when every the ignition is on.
WIRING UP THE 360º MODULE and the
MyGig INTERFACE
1.
The yellow wire is connected to constant power.
It can be found behind the radio on the 22—pin
gray plug pin 1- YELLOW/RED.
2.
The red wire is connected to accessory. It is
supplied from the interface. Connect the red
from the 360 module to the red accessory
output on the interface.
3.
Blue is connected to reverse. It is supplied from
the interface. Connect the blue wire from the
360 module to the purple reverse output on the
interface.
4.
Connect the RCA from the 360 module labeled
CVBS 1
to the interface RCA labeled AUX.
5.
Connect the RCA from the 360 module labeled
CVBS 2
to the interface RCA labeled REAR
CAMERA input.
6.
On the back of the radio unplug the factory gray
harness and plug in the gray T-harness in to
the back of the radio where the factory harness
was just unplugged. Plug the factory gray plug
into the other end of the T-harness.
7.
Plug the white 22—pin plug into the open plug
on the back of the radio.
8.
Check the system, by turning on the ignition and
shifting into reverse.
9.
You should see the backup camera. (If not the
RCA’s are connected backwards.)
10.
Calibrate the system.
