INSTALLATION INSTRUCTIONS
AVMS-3701v2 INSTRUCTIONS 8-7-16
Page 26 of 31
WIRING UP THE 360º CONTROL MODULE and FACTORY DISPLAY INTERFACE
1.
The yellow wire will be connected to vehicle constant power. Constant power can be found behind the radio on
the 22—pin gray plug pin 1- YELLOW/RED.
2.
The red wire will be connected to accessory power. Accessory power is supplied from the interface. Connect the
red from the 360º main control module to the red accessory output wire on the display interface.
3.
The blue wire will be connected to reverse. Reverse is supplied from the interface. Connect the blue wire from
the 360º main control module to the purple reverse output on the display interface.
4.
The white wire will be connected to Aux trigger input. Aux trigger input is supplied from the display interface.
Connect the white wire from the 360º main control module harness to the green aux trigger input wire on the
display interface.
5.
Connect the RCA from the 360º main control module labeled CVBS to the display interface RCA labeled AUX.
6.
Connect the RCA from the 360º main control module labeled CVBS RV to the display interface RCA labeled REAR
CAMERA input.
7.
On the back of the radio unplug the factory gray harness and plug in the gray T-harness in to the back of the
radio where the factory harness was just unplugged. Plug the factory gray plug into the other end of the T-
harness.
8.
Plug the white 22—pin plug into the open connector on the back of the radio. (There is no plug in this location
from the factory.)
9.
Check the system, by turning on the ignition and shifting into reverse.
