!
INSTALLATION!INSTRUCTIONS!
3600 Instructions 9-1-15
Page 5 of 19
9.
Route the harness in to the vehicle by
coming up though a grommet in the floor or
the grommet under the hood in the firewall.
10.
Route the rear camera harness to the 360º
module.
Section 4:
360º module installation
1.
Connect the correct camera plugs to the
360º module. Front, rear, left side, right
side, CVBS and CVBS RV.
2.
The CVRS output, is video output controlled
by the power on/off button to the system. It
is connected to the AUX video input on the
aftermarket radio/display.
3.
The CVRS RV output, is video output when
the accessory is powered on. It is
connected to the back-up camera input on
the aftermarket radio/display.
4.
If not done so yet connect the power
harness to the 360º module. Wire up the
power connections, yellow is constant, red
is accessory, black is ground, blue is
reverse.
5.
Do not mount the 360º module; you will
need to get to it for calibration of the
cameras.
6.
Plug in the Key Box and mount to the right
side of the steering column on the das trim
with the tape provided.
7.
To turn on the system press the power
button on the Key Box. To change camera
views press the car image button. A long
press will show a full front view another
long press will show a full rear view.
8.
Place the vehicle into reverse to see the
rear camera image on the screen.
