INSTALLATION INSTRUCTIONS
Outside Mirror Auto Dimming Kit (SKU # 9002-6014)
NOTE: Refer to main mirror kit instructions where applicable.
Description:
These leads allow the ability to add control of the outside rearview mirror auto-dim function to the 9002-9515
and 9002-9516 mirror.
Step 1):
Located on the bottom side of the 16-pin mirror connector is a rectangular white bar called a
Terminal Position Assurance (TPA) tab. Use Delphi Terminal Tool 12094429 or a small flatblade watch repair
screwdriver to release the TPA as shown. The TPA will only lift about 1/10
th
of an inch.
!
!"##$%&"'()*%$(*#+(,*%-(")(./''"'(
/.*0$1(
!
Step 2:
Insert supplied Orange lead into 16-pin connector cavity 5 and White lead into 16-pin connector
cavity 16 until they click into place. If they do not seat initially, use Delphi Terminal Tool 12094429 or a small
flatblade watch repair screwdriver to press the terminals fully into the connector. Next, press down on the TPA
to lock the terminals.
Step 3)
Follow the appropriate supplied charts to splice the Orange & White leads to wires in your vehicle
harness:
Brandmotion
Wire Color
Ford Mirror Connector
7 Pin
10 Pin
16 Pin
Description
Orange
Cavity 4
Cavity 8 Cavity 11
Mirror Feed +
White
Cavity 5
Cavity 7 Cavity 15
Mirror Feed –
Note:
Due to the large variations of vehicle models and years, you must follow the pin locations on the OE mirror
connector. This variability is why specific wire colors are not supplied here.
Brandmotion
Wire Color
Dodge Ram Mirror Connector
16 Pin
Description
Orange
Tan/Orange
Cavity 14
Mirror Feed +
White
Tan/White
Cavity 16
Mirror Feed –
For vehicles not listed, use a digital multimeter to identify the wires in the vehicle mirror harness that
feed the exterior auto-dimming mirrors. Splice the supplied Orange lead to Auto-Dimming (+) and the White
lead to Auto-Dimming (–).
Step 4)
Install mirror and camera as per instructions (supplied separately).
We strive to provide accurate and up-to-date installation instructions.
White dot
identifies
cavity 1
