INSTALLATION INSTRUCTIONS
Step 11: Use supplied Wire Ties to secure Chassis
Harness to fabric factory wire cover. CAUTION: Leave
enough slack to allow gate to open fully.
Step 12: Use a T20 Torx bit to remove subwoofer box.
Step 13: Using a plastic trim removal tool, pry off rear
seat belt closeout.
Step 14: Using a plastic trim removal tool, remove rear
access panel to expose 10mm bolt, and remove bolt.
Step 15: Pull out subwoofer box slightly to gain access
to run Chassis Harness along existing harness
Step 16: Pull back carpet and continue running Chassis
Harness forward.
Step 17: Run Chassis Harness under B-pillar cover to
passenger door sill. Use a plastic trim removal tool to
remove the (2) plastic push pins and remove passenger
sill plate/kick panel.
9002-8848 Instructions 6-10-19
Page 4 of
7
KB
