INSTALLATION INSTRUCTIONS
9002-2772 v1 11-7-2016.doc
Page 2 of 2
GS
Backup camera interface for select Audi
vehicles with the internal MMi media system
(MMi controls on radio face, not the console).
1.
Remove the factory screen. The screen is
removed by pulling panels and removing
screws. Each car is different on its
disassembly.
2.
Disconnect the square LVDS connector from
behind the screen.
3.
Connect the provided LVDS output cable to
the back of the screen where the factory
connector was just removed. (The output
cable has a small black plug on one end).
4.
Connect the provided LVDS input cable to
factory connector that was plugged into the
screen. (The input cable has a small WHITE
plug on one end).
5.
Route the 2 LVDS harnesses to where the
module will be installed. (There is usually
room behind the glove box).
6.
Plug in the 2 LVDS cables to the correct
locations on the 9002-2772 module. (They
are white and black).
7.
The RED wire on the POWER/CAN harness
is 12V accessory. The best place to find
accessory is at the passenger fuse box. It is
black/white or black/blue. Use this wire to
power the camera also.
8.
The BLACK wire on the POWER/CAN
harness is ground.
9.
There are 2 sets of CAN wires: CAN1 and
CAN2. Connect the 2 CAN HI (BLUE and
GREEN) and the 2 CAN LOW (WHITE and
PINK) together.
10.
CAN wires are twisted or spun together in
the factory harness. Connect CAN HI to the
ORANGE/BLUE vehicle CAN wires and the
CAN LO to the ORANGE/BROWN vehicle
CAN wires. Connection can be made either
behind the glove box or the climate control
unit.
11.
If you do not want to use CAN to trigger
reverse, connect the GREEN wire to
reverse. (Use a relay to isolate the reverse
wire).
12.
Connect the camera to the yellow video
RCA input labeled CAMERA.
13.
Check to see if camera image is displayed
on the screen. Start the vehicle, Press the
parking brake on and put the car in reverse.
14.
Reassemble in reverse order.
15.
All other cables are not needed for this
install.
DIP Switch Settings
DIP switch 10 is always ON (DOWN
)