Bramwell Brown Tide Clock, Instruction Manual

Page: 9 / 20

Bringing the Harbour Scene to life
with the Demonstration Function
Top Tip!
Your Tide Clock will move on its own every fifteeen minutes,
however, pressing the demonstration button allows you to show
a full loop of the tide scene and dials, as would be normally be
shown over the course of an entire lunar day.
You can activate this ‘Mechanimation Function’ any time by
pressing the button on the bottom of the clock. You’ll need to
hold the button down momentarily (approximately one second)
for it to activate.
The button can be a little stiff but press it firmly until you hear a
click. We always recommend holding the clock with your other
hand whilst pressing the button. If the button is pushed too
enthusiastically with one hand only, it could lift off its wall fixing!
How often the demonstration button is pressed will determine
how long the batteries last. When the batteries get low on
power, the lighthouse will start to do a double flash, at which
point it’s probably time to buy a new set of D-cell batteries.
7
Bottom of clock frame
Demonstration button