311-0288-281 Rev. A 2/13
© 2013 Hopkins Manufacturing Corporation
1-800-470-2287 5
STEP 2: PoSITIoN mAIN UNIT (A)
1. Take main unit and position in the most convenient, out of sight place in the towed vehicle. Below are some
suggested mounting locations.
2. Ensure there is an optimal way to route the cable from the main unit to the brake pedal. A 90° bend is allowable with
minimum radius of 6 inches.
3. Route cable to brake pedal. Allow enough cable to be able to hide under thresholds and floor mats. DO NOT attach
the main unit at this time or cut cable to length.
UNdER THE SEAT
IN THE TRUNK
NOTE
May want to check with RV’er to see
where they would like it placed.
WARNING
Main Unit is not designed to be installed outside the
towed vehicle or within the engine area
STEP 3: moUNTING loCATIoN foR PUllEy ANd BRAKE PEdAl ClAmP (B)
1. Position brake pedal clamp above the brake pedal as shown
in (Figure 1). The brake pedal clamp is attached with bolts in
the pre-drilled holes on the brake pedal clamp. Ensure bolts
are placed as close to the brake pedal arm on each side.
STEP 4: moUNT PUllEy To flooR BEHINd BRAKE PEdAl (B)
1. Position pulley with large hole downward as shown in (Figure 1).
2. Mount pulley to floor of towed vehicle with the 4, 1.5” self
tapping screws provided.
WARNING
Make sure the exit side of the screws will not damage
components on the other side of the firewall.
WARNING
Verify the brake pedal clamp does not interfere with the total
downward movement of the braking action.
NoTE
Ensure the pulley is directly in-line with the hole in the angle on
the brake pedal clamp as shown in (Figure 2).
Figure 1
Figure 2
