...............................................................................................................................................................................................................................................
Note: This document does not replace the user guides.
Page 1/4
CURVE SYSTEM SETUP
OR SETUP
• Place
Camera Cart
1.2 - 1.8 m (4 - 6 ft) away from
the operating field.
NOTE:
Do not position any part of the
Camera
a
and
Monitor Carts
s
directly over the patient.
CONNECT CAMERA CART TO MONITOR CART
• Plug Brainlab’s camera cable into the base of
Camera Cart
and connect to the back panel of
Monitor Cart
.
• Pull gently at the connector to confirm that it is
locked.
• Plug in mains power cable to wall outlet (not shown).
NOTE:
For information on connecting the EM
Tracking unit, refer to the corresponding System
User Guide.
POWER ON CURVE SYSTEM
• Turn on mains power switch on the user panel of
Monitor Cart
a
.
POWER OFF CURVE SYSTEM
• Exit the software and wait until the power LED
a
turns off.
• Turn off mains power switch
s
and wait until the
mains power LED
d
turns off.
NOTE:
Wait for the system to fully shut down before
turning off mains power switch.
NOTE:
After shutting down
Curve
, wait at least 60
seconds before turning back on again.
Hardware: Curve 1.2
a
s
s
d
a
a
