IRX Tray Setup
INFRA
COM®
6
Copyright by Brähler ICS
IRX Tray Setup
This program allows adjusting various operating parameters of the
IRX
infrared receiver for up to 50 devices
simultaneously in the TK50 charging tray. Just connect the LKC50 programming device between the power
supply and the included AC charging adapter of the TK50 charging tray. The LKC50 programming device
connects to a RS232 serial port of a PC or notebook. The figure on the next page shows a schematic wiring.
Only
IRX
receivers with firmware revision V2.6 or later can be programmed through the TK50
charging tray. The firmware revision will be shown briefly when starting the
IRX
receiver.
The setup version will install both versions V2.6 for IRX with firmware 2.6 - 3.0 and a version V5.1 for
IRX with firmware > 5.0
A display of e.g. 30 after starting the receiver means Firmware version 3.0.
Installation
For installation under Microsoft Windows™ the provided file “setup_IRX.exe” must be executed.
The following window appears:
Click „Next” (here “Weiter”) to start the installation of IRX tray setup.
A new program group “BRAEHLER” will be created after successful installation. Here you will find the actual
program as well as the operating instructions as PDF-document.