3
Installation
S19-220SC
Bradley Corporation • 215-158SC Rev. G; EN 06-532E
4/23/07
Installation
NOTE: Flush the water supply line before
beginning installation.
Supplies Required:
• (2) 1/4" bolts and wall anchors for
mounting wall bracket
• Pipe sealant
• Piping to 1/2" IPS water supply inlet on
unit
• Piping to 1-1/4" IPS drain outlet for
eyewash
• Sign-mounting hardware
Step 1: Install wall bracket
NOTE: The top of the eyewash heads should
be 33"–45" (838mm–1143mm) from the floor.
1. Position the wall bracket on the wall.
2. Using the wall bracket as a template,
mark the bolt hole locations on the wall
OR install two suitable fasteners
(supplied by installer) for 1/4" bolts in
the wall at the marked hole locations (see
Figure 1).
Step 2: Assemble eyewash
components
1. Assemble eyewash components as shown
in Figure 2 on page 4.
• Apply pipe sealant (supplied by
installer) to all male-threaded pipe
joints.
• Use a strap wrench around pipes when
tightening to prevent marring.
Step 3: Connect water supply
1. Connect the water supply piping
(supplied by installer) to the 1/2" IPS
inlet on the eyewash.
2. Connect the tailpiece to the 1-1/4" IPS
drain outlet on the eyewash (see Figure 2
on page 4).
3. Mount the safety sign to the wall using sign-mounting hardware (supplied by installer).
4. Open the water supply lines. Test for leaks and adequate water flow.
4"
(102mm)
7-1/2"
(191mm)
8
-
3
/4"
(222mm)
5-1/4"
(1
33
mm)
17-1/4"
(4
38
mm)
Ø 10-
3
/4" (27
3
mm)
1
3
-1/2"
(
3
4
3
mm)
Wall
21-1/2" (546mm)
8
-1/
8
"
(206mm)
4-1/2"
(114mm)
7-1/4"
(1
8
4mm)
3
0-1/2"
(775mm)
S
u
gg
e
s
ted
Hei
g
ht
To Floor
3
6"
(914mm)
S
u
gg
e
s
ted
Hei
g
ht
To Floor
Figure 1
