3
Installation
S19-220DCRPT
Bradley Corporation • 215-1256 Rev. E; EN 06-532G
4/30/07
Installation Instructions
NOTE: Flush the water supply line before
beginning installation.
Supplies Required:
• (3) 3/8" wall fasteners and bolts
• Pipe sealant
• Piping to 1/2" IPS water supply inlet on unit
• Sign-mounting hardware
Step 1: Install inlet drain fittings
NOTE: Top of eyewash heads should be 33"-45"
(838mm-1142mm) from floor.
1. Position the inlet drain fitting over the 1-1/4"
drain outlet pipe from wall.
2. Using the inlet drain fitting as a template,
mark the bolt hole locations on wall OR install
three suitable fasteners (supplied by installer)
for 3/8" bolts in the wall at the marked hole
locations (see Figure 1).
3. Bolt the inlet drain fitting to the wall or wall
fasteners using 3/8" bolts (supplied by
installer).
Step 2: Assemble eyewash
1. Assemble eyewash components as shown in
Figure 2 on page 4.
• Apply pipe sealant (supplied by installer) to
all male-threaded pipe joints.
• Use a strap wrench around pipes when
tightening to prevent marring.
Step 3: Connect water supply
1. Connect the water supply piping (supplied by
installer) to the 1/2" IPS inlet on the eyewash.
2. Connect the P-trap and tailpiece to the 1-1/4"
IPS drain outlet on the eyewash.
3. Mount the safety sign to a wall or pipe using
sign-mounting hardware (supplied by
installer).
4. Open the water supply lines. Test for leaks and adequate water flow.
17-1/4"
(4
38
mm)
8
-
3
/4"
(222mm)
21-1/2"
(546mm)
14"
(
3
56mm)
8
-
3
/4"
(22
3
mm)
8
-1/4"
(210mm)
4-5/
8
"
(119mm)
1
3
-5/
8
"
(
3
46mm)
Ø10-
3
/4"
(27
3
mm)
2-1/4"
(57mm)
Ø5/16"
(
8
mm)
MTG.
HOLE
4"
(102mm)
5-1/4"
(1
33
mm)
3
6" (914mm)
S
u
gg
e
s
ted
Hei
g
ht
To Floor
3
0-1/2" (775mm)
S
u
gg
e
s
ted
Hei
g
ht
To Floor
Figure 1
