Lenox
®
Locker (includes Cubby & "Z" Lockers)
Installation
12 10/19/2017
Bradley •
LK-INSTR-001 Rev. N; ECN 17-13-005
Figure 7d
Figure 7e
FLAT TOP
Start at the corner and work
outward as shown .
Drill holes equidistant
from locker front to
back .
2" x 2" CORNER
SUPPORT BLOCKING
(supplied by installer) .
Make sure the edge of
the flat top with the radius
is facing the front of the
lockers as shown .
Optional Locker Flat Top Installation
7b
The flat tops are shipped in standard lengths and can be
easily modified during installation. This is often necessary
to overcome a variety of installation situations. Use a
panel saw to cut the flat top sections to the proper length if
necessary.
1 . Drill the appropriate number of 3/16" dia . clearance holes
through the top of the installed lockers equidistant from
locker front to back (see Figure 7d) .
• Locker screw hole requirements: flat tops less than
18" long, two holes; 18"–35" long, three; 36"–45"
long, four; 72" long, six .
CAUTION To prevent injury, make sure the radiused
edge of the flat top is facing the front of the
lockers, and the sharp edge is facing the
back of the lockers.
2 . Starting at the corner and working outward, secure
the flat top to the locker with the #8 x 1-1/8" Lg .
screws (provided by installer) (see Figure 7e) . Do
not overtighten screws .
3 . If desired, caulk the gap in the back edge of the flat
top where it meets the wall .
4 . Measure, modify and install the remaining flat tops
for a custom fit .
