Aerada 1100 Series High Arc Faucet
Installation Instructions
6
3/8/07
Bradley Corporation • 215-1558 Rev. A; EN 07-202
Changing the Sensor Detection Range
Changing the Battery
NOTE: The detection distance setting can be used to change
the detection distance.
1. Cover the infrared window as shown below. Water will
switch off after 5 seconds. Keep the window covered and
the water will come back on after another 5 seconds.
Uncover the window. The detection distance function is now
active.
NOTE: When the battery is low, the sensor will display a
continuous signal until the battery is completely dead.
1. Remove the fixing screw with wire from the back of the
spout and the setscrew from the side of the spout. Remove
the external temperature control knob and the spout.
2. Remove the old battery and replace with a new 6-
volt lithium battery.
3. Reinstall the spout, fixing screw with wire,
temperature control knob and setscrew.
2. Hold your hand in the current detection area (under
the water flow) until the LED flashes.
3. Move your hand to the desired detection range.
When the LED stays lit for 2 seconds, detection
range is set.
