Aerada 1000/1100 Series
Installation
4
5/21/08
Bradley
Corporation
• 215-1628 Rev. A; EN 08-201
INSTALLATION
This faucet comes with all the components needed for installation,however, some
tools and supplies are not included.
• Basin Wrench
• Adjustable Wrench
• Adjustable Locking Pliers
• Plumber´s Putty
• Hex Key (supplied)
• Outlet Key (supplied)
Do not use pipe dope on faucet and supply connections. Possible
solenoid contamination could occur and will void any warranty.
Mounting of Lavatory and Gooseneck Faucet
Prerequisites
• Supply valve is installed
• Water supply lines are fl ushed properly
• For AC faucets, power outlet is installed
It is not necessary to unscrew the connection between braided hose
and housing to install the product.
Do not remove protective covering from sensor until starting up faucet
operation.
Do not tighten locknut before step 4 is completed.
1
Mount cover plate if required. Plumber´s putty is recommended to seal the
cover plate to the sink. Security pin must be located on the left side.
2
Mount gasket and put faucet into sink.
3
Mount bracket from underneath. Place hoses through large opening and
mounting rod through small opening. Make sure fl ange sits securely against
surface.
4
Place nut onto mounting rod and tighten with wrench.
5
If faucet was installed with cover plate, secure with basin washer, fl at washer
and locknut.
6
Install aerator and tighten with aerator key (supplied).
7
For Gooseneck faucets, tighten spout with wrench.
8
Connect braided hose with fi lter to supply valve
Cold water > white label Hot water > no label
For AC faucets, please refer to the plugin or hardwired transformer
installation instructions.
9
Connect to power supply.
Result:
The faucet is now mounted.
