270
Multi-Purpose Unit - Towel Dispenser/Hand Dryer/Waste Receptacle
© 2017 Bradley
P.O. Box 309, Menomonee Falls, WI 53052-0309
800 BRADLEY (800 272 3539)
+1 262 251 6000
bradleycorp.com
Page 2 of 2
12/11/2017
This information is subject to change without notice.
Bradley_CombiDispenser_270_10_11
Sensor Activation
Universal Voltage
Not recommended for high traffic, high vandal-prone applications
Product Materials
Cover:
powder-coated aluminum alloy, white.
Motor:
7500 RPM brush type.
Heating Element:
industrial strength coil would on mica support protected by
temperature limit control.
Electronic Control:
active infrared sensor.
Circuitry:
infrared red microprocessor control allows for multi-voltage application.
9"
(229mm)
9¾"
(248mm)
4"
(102mm)
Side View
Front View
7"
(178mm)
7
/
8
" (22mm)
electrical
knockout
4
1
/
8
"
(105mm)
2¼"
(57mm)
¾"
(19mm)
6
3
/
8
"
(162mm)
Mtg. Hole Locations
(Front View)
Operation
Place hands 3" - 6" below nozzle to activate dryer.
Installation
Verify all rough-in dimensions prior to installation. Refer to mounting hole locations
shown on the left. Mark the location of the four mounting bolt holes. When two or
more dryers are installed, they should be placed no closer than 24" (60 cm) from
center to center. Use the security hex driver to loosen the cover screws. Remove
the cover from the dryer. Attach the mechanism firmly to the wall using appropriate
fasteners. Run the supply wiring to the dryer and connect it to the terminal block.
The ground wire must be connected to the base plate. Replace the cover. Do not
overtighten the screws. There may be a delay when power is first applied.
Guide Specification
Surface-mounted hand dryer shall protrude 4" (102mm), fabricated from powder
coated cast aluminum. Contain Universal voltage capability. Dryer shall be activated
by means of an infrared emitting/receiving electronic control device, automatically
detecting hands when present. Dryer operates at 76 dB while delivering 134 CFM
during user-controlled drying cycle.
Overall dimensions: 9"W x 9¾"H x 4"D (including nozzle tip).
ADA Compliant
Consult local and national accessibility codes for proper
installation guidelines.
Conformity and compliance to local and national codes is the
responsibility of the installer.
Volts
Amps
Watts
Frequency
115
10
1150
50 or 60 Hz
208
6
1150
50 or 60 Hz
240
5
1150
50 or 60 Hz