Remote Mounting the Setback Control
-59-
Install Wire (A) – Backplate
Step 7: Using wire (A), insert one end into the top terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 88. Be sure that the wire already
located in this location is not dislodged.
Fasten Wire (A) into its Designated Location – Backplate
Step 8: Tighten the slotted screw in the top terminal location on the backplate (located on the Setback
Control Junction Box Assembly). This is shown in Figure 89.
Figure 89
Figure 88
Backplate
Wires Already
Installed
Wire (A)
Wire (A)
Slotted head
screwdriver
Backplate
Setback Control
Junction Box Assembly
Summary of Contents for ACCESSORY MODULE
Page 12: ...Wiring Diagram 12...
Page 74: ...Notes 74...
