IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers
seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic
parts of a vehicles dash.
WARNING:
Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED:
MVM-35-05 Mount, 3 - #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel and Hardware.
TOOLS NEEDED FOR MVM MODIFICATION
(
if required
)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
# 2 Phillips Screwdriver
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Begin installation by removing the long trim on the right side of the
radio/ center console. Insert a Dash Trim tool (part #SIT-104) in the
location as shown in the picture to the left. Work your way along this trim
releasing all the clips.
Note:
Some of the clips are tight. Use caution. Set
the trim aside in a safe place.
Ship to
Step 5
on the following page if you have not yet formed the
bracket to fit your vehicle.
Remove the one (1) Phillips screw on the right side of the radio, just below
the knob on the right side. Set the screw aside in a safe place. Place the
MVM over the hole and replace the factory screw.
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete
Install
Mount Here
1
2
3
4
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.