- 9 -
Fig. 2
1
3
4
5
Tota
l Tim
e 3
Total Time 4
Total Time 5
The Profile of each move is stored with each position.
Fig.2
illustrates that each move TO a
pre-set position will take the time associated with that end position. Understanding this
enables efficient use of the same start position.
8
6
7
1
Total T
ime 1
Total Time 1
Total T
ime 1
Fig. 3
Fig.3 illustrates the opposite situation to Fig.2. Because each of these moves ends with
position 1, each move will take the same amount of time
– as defined by the profile associated
with position 1. Therefore, the move from position 8 will be the fastest.
If the move is taking too long the operator simply needs to push the pre-set position button
again and the camera will reposition as fast as possible.
The camera will make the profile move from
wherever it is
to the pre-set position selected,
always in the same amount of
Time
. Therefore, the camera will move faster if the move is
further.
To perform the same move repeatedly use 2 pre-set positions. 1 for the start position and 1 for
the end position.
D* Commands for the Camball4
The position of any axis can be requested from the camera. This is useful if you are not using a
virtual model of the
Camball4Ki
and need to generate your own reference positions.
If you need to write your own control commands please ask
BR Remote
for the full Dstar &
Mstar Protocol documents including the full command list.