PROG
PROG
PROG
PROG
F
G
M1
A
PROG
PROG
>3’’
A
PROG
1 P.E.
PROG
2 P.E.
PROG
1 P.E.
PROG
2 P.E.
PROG
1 P.E.
PROG
2 P.E.
PROG
1 P.E.
PROG
2 P.E.
B
M1
A
PROG
PROG
<1’’
H
C
D
E
a
b
a
a
Pa
ge
4
- M
an
ua
l
FB
00
33
2-
EN
- v
er
s.
1
- 0
5/
20
16
- © C
am
e S
.p
.A
. - T
he c
on
te
nt
s o
f t
he m
an
ua
l a
re t
o b
e c
on
si
de
re
d a
s s
ub
je
ct t
o c
ha
ng
e a
t a
ny t
im
e a
nd w
ith
ou
t t
he n
ee
d f
or a
ny a
dv
an
ce w
ar
ni
ng
.
PROGRAMMING ENTRY PANELS WITH VA/01 OR A/01
Programming for the first time
Programming buttons
Press the first call button on each unit
C
D
(see the “call num-
ber” section).
The LED lights on the unit remain on to show that the buttons have
been programmed correctly.
NOTE. For the basic unit (no call buttons), you do not need to
press the buttons that are shown as flashing in figure
B
a
.
Repeat for all entry panels to be programmed. Once programming
is complete, the configuration is implemented
E
and you are au-
tomatically taken to “programming calls”.
Programming calls
The PROG LED on the entry panel flashes and a beep sounds to
signal that you have entered programming mode
F
. Lift the in-
ternal receiver handset (if present) and press the door lock release
and AUX2 buttons
F
. On the entry panel, press the call
button to be linked to the internal receiver
G
a
. A beep confirms
that the setting has been stored
G
b
. End the call and repeat for
the other internal receivers.
NOTE. The operation can only be carried out from an entry
panel with the beep active. To change the entry panel from
which calls are programmed, press one of the call buttons on
the entry panel you wish to use for programming.
NOTE. You can force the switch from one programming mode
to another by pressing the PROG button on the power sup-
ply unit for 3 seconds and releasing within 6 seconds. If you
force the switch to call programming from button program-
ming, the button units which have not been programmed are
configured to 8 calls. If the base unit is not programmed,
calls are not configured.
Exiting Programming
Press the PROG button on the power supply briefly
H
. The LED
switches off and the entry panel stops ringing.
Entering programming mode
Press the PROG button on the power supply
A
until the PROG LED lights up.
The PROG LED on the entry panel flashes slowly and the buttons flash
B
to show the
buttons are being programmed
