Flush Mount
Mounting of ULTRA50 EXIT Sign to Surface
1.
Place the EXIT Sign in position and mark the screw hole locations.
2.
If wall anchors will be required, install them at this time (Supplied).
3.
Attach the ULTRA50 EXIT Sign to the wall by using the two supplied #8 Phillips head screws. Be careful not to over
tighten the screws.
4.
If a directional arrows are to be used, apply them to the EXIT Sign at this time.
a.
Alignment dots are provided on the face of the sign to ensure proper positioning of the arrows.
i.
For Exit paths straight ahead, no arrows are needed.
ii.
For Exit paths to the left, apply the arrow on the left side of the EXIT Sign.
iii.
For Exit paths to the right, apply the arrow on the right side of the Exit Sign.
iv.
If Exit paths are located to the left and right, apply both arrows to the EXIT Sign.
Flag or Ceiling or T-Bar Mount
Installation Instructions for the ULTRA50 EXIT Sign
1.
If directional arrows are to be used, apply them to the EXIT Sign at this time.
a.
Alignment dots are provided on the face of the sign to ensure proper positioning of the arrows.
i.
For Exit paths straight ahead, no arrows are needed.
ii.
For Exit paths to the left, apply the arrow on the left side of the EXIT Sign.
iii.
For Exit paths to the right, apply the arrow on the right side of the Exit Sign.
iv.
If Exit paths are located to the left and right, apply both arrows to the EXIT Sign.
FOR FLAG MOUNT
2.
Place the EXIT Sign
bracket
in position and mark the screw hole locations.
3.
If wall anchors will be required, drill 4ea 3/16” holes and install them at this time (Supplied).
4.
Attach the EXIT Sign
Bracket
to the wall using the supplied #6 screws and anchors.
5.
Drill two 3/32” holes in the sign face on the where indicated by the alignment dots near the end of the sign.
6.
Slide the mounting bracket onto the side of the exit sign and align with the drilled holes.
7.
Attach the ULTRA 50 EXIT sign to the bracket and secure into place by inserting the screws and tightening the acorn nuts
which are supplied with the sign.
FOR CEILING MOUNT
2.
Place the EXIT Sign
bracket
in position and mark the screw hole locations.
3.
If wall anchors will be required, install them at this time (Supplied).
4.
Attach the exit sign Bracket to the ceiling using the supplied #6 screws and anchors.
5.
Drill two 3/32” holes in the sign face where indicated by the alignment dots near the top of the sign.
6.
Slide the mounting bracket onto the top exit sign and align with the drilled holes.
7.
Attach the ULTRA 50 EXIT sign to the bracket and secure into place by inserting the screws and tightening the acorn nuts
which are supplied with the sign.
FOR T-BAR MOUNT
2.
Place the EXIT Sign
bracket
in position and attach using the supplied T-Bar clips.
3.
Slide the mounting bracket onto the top exit sign and align with the pre-drilled holes.
4.
Attach the ULTRA 50 EXIT sign to the bracket and secure into place by inserting the screws and tightening the acorn nuts
which are supplied with the sign.
B R I G H T PAT H L I G H T I N G , I N C .
Ph. 559-443-7300
877-343-7300
2910 E. Heaton Ave.
Fresno, CA 93721
www.bplighting.com
SAVE THESE INSTRUCTIONS
