BP 06J FOLDING ELECTRIC WHEELCHAIR
Installation of the safety belt:
1. The user needs to ensure that the safety belt had bound the waist and the bottom part of wheelchair
backrest together.
2. Adjust the safety belt according to the user’s comfort.
After sitting down, please insert the plastic card to the other side of the plastic shell, until you hear
a clicking sound.
Adjust the plastic safety belt to the appropriate length, do not over tighten, which will cause discom-
fort.
Unfasten the safety belt:
Press the button of the plastic shell aside, pull out the plastic card.
Before each use, ensure that the safety belt is fixed in the electric wheelchair correctly and properly, and
adjust to the most comfortable state of the user.
Before each use, check whether the safety belt is loose or damaged. If you find there is a problem, Please
contact supplier to maintain and repair.
The control panel can be installed on the left or the right arm as requested.
1. As shown in figure D1, insert the joystick into the armrest tube hole, and make sure it has been insert-
ed in the right place, and then fixed the joystick with rubber-head bolt.
2. As shown in figure of D2, aim at the socket, and insert the
4-5 coreplug
into the left sockets.
The control panel controls electric wheelchair. It consists of the following sections:
Installation instruction
D1
D2
17
Caution
Joystick Installation Instruction
CARE and CAUTION must be provided whilst connecting and disconnecting joystick connector.
Mishandling of the connectors can cause the pins to bend. This is classed as USER ERROR.
