Radio tuning
1. Turn the volume knob in a clockwise direction to turn the equipment on.
2. Use the function selector to select TUNER mode.
3. Use the radio band selector to select the desired band (AM, FM or FM-Stereo).
4. Turn and hold the tuning knob for a few seconds to tune into a radio station. The unit will start
searching automatically and stop when a radio station is found. Release the knob once a
station has been found.
5. Repeat the above step until your desired radio station is found.
6. Adjust the volume knob to your desired volume level.
7. AM reception
: the receiver has a built-in AM bar antenna. If reception is weak, slightly rotate
or reposition the unit to improve AM reception.
8. FM reception
: the receiver has a built-in FM wire antenna hanging at the rear cabinet. For best
reception, completely unravel and extend this wire.
9. When you have finished listening to the radio, turn the volume knob in a counterclockwise
direction to switch the unit off. Unplug it from the power supply if you are not going to use it for
a while.
FM and FM-stereo mode
• FM mode:
use the radio band selector to select the FM band. Programs are received in mono
mode. Use this mode when stereo reception is weak.
• FM-Stereo mode:
use the radio band selector to select FM-ST for receiving stereo programs.
Once a stereo signal is received, the ST icon will light up on the display.
The record player
IMPORTANT!
When using the turntable:
• Make sure to remove the stylus protector, as illustrated on the right. (It should easily slide off
the stylus assembly.)
• Make sure to unclip the tone arm lock before use and to secure it again after use.
