30
Cleaning, maintenance and maintaining
Jelly power pack Edition 09.09
5.7
Exchanging the agent-hose
The agent-hose may only be exchanged
•
by skilled technical personnel.
•
when it is not connected to the
electric
power
supply
and
not
pressurised.
•
when it is cold.
- Disconnect the coupling plug between the jelly
container and the suction-hose. Refer to chapter
"Connect the one-way jelly container BIB", page
16.
- Go on spraying your pastry until only an jelly-air-
mixture will emerge the spray gun.
- Switch off the implement.
- Pull the CEE-power plug from the socket.
- Separate the implement from the external
compressed air source.
- Actuate the spray gun and thus discharge the
residual air pressure out off the system.
- Open the implement housing. Refer to chapter
"Opening and closing the implement housing",
page 28.
- Remove the cable ties (1) and the cable
protection (2).
- Disconnect the two plug connectors (3).
- Slacken the agent-hose screw joint (4).
- Slacken the screw joint (5).
- Pull the agent-hose out of the implement housing.
- Unscrew the spray gun from the agent-hose.
- Connect the new agent-hose in reverse order.
- Shut the implement housing again with the front
side.
You
may
connect
the
two
plug
connectors as desired.
In case of queries, please do not hesitate
to contact our after-sales service.
Summary of Contents for Jelly power pack
