BDA-SERIES
Power Full CLASS-D Power Amplifier
13.
30Hz LOW CUT FILTER:
eliminates unwanted subsonic frequencies under 30Hz. In most cases these
frequencies only consume a lot of energy without any added value to the music.
14.
OPERATION MODE switch:
Used to set the operation mode of the amplifier. The most common
operation
mode is “stereo” . If you need more power, you can operate the amplifier in bridge mode. In
mono mode you only have to connect the left input to drive both outputs. Refer also to n
⁰
3 for more
information.
15.
INPUT SENSITIVITY SWITCH
: you can choose 3 different input levels: 26 dB / 32 dB / 1,4V
16.
BALANCED XLR OUTPUTS:
Can be used to send the signal to the next amplifier. Pin1: signal ground,
Pin2: , Pin3: Signal-
17.
BALANCED XLR INPUTS:
Pin1: Signal ground, Pin2: , Pin3: Signal-
HOW TO USE
STEREO OPERATION:
• Connect the audio signal to the inputs (15 or 16)
• Set the operation mode switch (13) tp “stereo”
• Connect the matching speakers to the L+R Speakon® outputs (11)
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket
• Set both input gains (2) to zero
• Make sure there’s a music signal at the input
• Turn the amplifier on (8)
• Adjust the input gains (2) to the desired level
BRIDGE OPERATION:
• Connect the audio signal to the left input (15 or 16)
• Set the operation mode switch (13) tp “bridge”
• Connect the matching speakers to the Bridge outputs (12)
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket
• Set both input gains (2) to zero
• Make sure there’s a music signal at the input
• Turn the amplifier on (8)
• Adjust the left input gain (2) to the desired level, leave the right channel gain to zero
MONO OPERATION:
• Connect the audio signal to the input of the left channel (15 or 16)
• Set the operation mode switch (13) tp “mono”
• Connect the matching speakers to the L+R Speakon® outputs (11)
• Make sure the mains voltage matches 230Vac before connecting the
mains cable to the earthed wall socket
• Set both input gains (2) to zero
• Make sure there’s a music signal at the input
• Turn the amplifier on (8)
• Adjust the left input gain (2) to the desired level, leave the right channel gain to zero
