BOXLIGHT Mimio MyBot, Assembly Instructions Manual, Page: 11 / 18

MyBot Base Kit Assembly Instructions v1.4a Page 11 of 18
(For kits supplied with black wheels)
MyBot Base Kit | Assembly Guide
STEP 18 – Attaching the Fusion Controller:
18. Using the M4 x 8mm screws, mount the Fusion
Controller to the standoffs on the top-side of the robot
as shown.
a.
Before mounting, you might want to consider
neatening the wires from the sensors and use small
twist-ties or cable-ties to keep them in place.
STEP 19 – Wiring the Robot:
19. Referring to the Wiring Chart, insert the wires into the
correct ports on the Fusion Controller.
a.
Note that with the word Fusion toward you, all of
the black wires are to the right – with one
exception: M0 (the right motor).
b. It is recommended to connect the battery wire last .
NOTE: For Planetary Exploration Kits, see the additional
connection information in the box below.
1x 4x
(8mm)
M1 – Left Motor
M0 – Right Motor
For Planetary Exploration Kits, connect the
additional sensors as follows:

The Color Sensor is connected to an I2C Port

The Magnetic Sensor is connected to Port A1.