Page 26/42
MULCHING MOWER MASTER SERIES | User manual
February 2021
6.
IMPORTANT NOTES PRIOR TO COMMISSIONING
Fill angular transmission with oil! For reasons of freight forwarding, the transmissions are dry and must be filled with
oil prior to operation. Please use a 80W90 transmission oil for filling. Please refer to the figures for where the oil is
filled and the fill volume. If necessary, seal the filler plugs/inspection plugs with Teflon sealing tape.
The angular transmission is half filled with oil. The fill volume should
be inspected visually or by inserting a dipstick that can be easily made
from a piece of wire.
The transmission has a capacity of 1000 ml when empty.
The universal shaft must be filled with 300 ml of oil. If there is no filler
plug on the universal shaft, a closed bearing has been installed. In this
case, no oil fill is necessary.
Examine all screws for tightness and retighten if necessary.
Adjust the black universal shaft guard on the transmission.
The mower units are delivered with sufficiently long universal shafts to allow them to be attached to all tractors.
Different PTO shaft lengths may be necessary for different tractor models. If necessary, the PTO shaft must be
shortened to the appropriate size. Please proceed as follows: With the mower unit attached, the PTO shaft should
still have at least approximately 5 cm movement, i.e. be able to be pushed inwards 5 cm. To shorten it, disconnect
the two universal shaft halves by them pulling apart. The PTO shaft can then be shortened to the correct length
using an angle grinder or a saw.
Lubricate all lubrication points via the grease nipples.
The universal shaft speed should be set to 540 rpm. Only intended for right-rotating PTOs, i.e. for rear attachment
to the tractor.
