© Pro-Ject Audio Systems · Pro-Ject Media Box S · Revision 16.05.2015
5
Technical specifications Pro-Ject Media Box S
Audio formats:
MP3, WMA, AAC (no DRM support)
USB-input:
High-Speed 2.0. Typ A-socket.
Suitable for flash drive and hard disk
(with power out for hard disk drive)
Accepted hard disk drive format:
FAT 32 (no NTFS support)
Card reader:
SD card (secure digital), max. 32GB
Line-level output:
1 pair RCA/Phono sockets
Output voltage:
max. 1Vrms
Noise floor
100dB/1V
Digital output:
co-axial (S/PDIF)
D/A-converter:
Texas Instruments TLV320AIC23B. 24Bit/96kHz, upsampler
Outboard power supply:
9V/2A DC, suitable for your country's mains supply
Power consumption:
9V/1,8A DC max. – with hard drive connected
Replacement battery remote control:
1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions W x H x D (D with sockets): 103 x 36 x 103 (109)mm
Weight:
550g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons, release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright © 2015. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
