02
1. First task: fit your safety ring
2. Second task: fit the main spring
Screw the 10mm studding into
the front of the casting and
lock off with the 10mm nut.
Remove the
‘
R
’
clips from the
sockets underneath the clay
plate at the rear of the trap and
insert the safety ring ends.
Align the holes and secure by
pushing the
‘
R
’
clips through the
socket and safety ring. Finally
lock the two 10mm nuts up to the
steel tube at the front of the
safety ring.
For safety reasons your clay
pigeon trap is supplied with the
main spring detached. Remove
the cable ties to access the spring;
place the spacer, washer, tension
handle and wing nut to the side in
the order you removed them from
the spring studding.
To re
-
attach the main spring,
rotate the throwing arm over the
casting until it points straight
ahead. In this position there is no
tension on the main spring,
allowing you to fit the M12 stud-
ding through the rod bearing at the
rear.
Once through the bearing, add the
spacer (the narrow end slots into
the rod bearing), washer, tension
handle (to a desired tension) and
lock securely with the 12mm wing
nut.
Summary of Contents for SUPERMATCH 6/8 ABT
Page 7: ...07 ...
