125
13. Using a 17mm open end wrench, loosen and remove the indicated nut
from the Left Lower Shroud. Carefully pull the Power Inlet plug out of the
hole toward the inside of the Shroud.
NOTICE:
Observe the routing of the 2 Power Inlet wires to the
Servo Motor on the right side of the frame and the
PCBA Slim Control Board at the front of the frame.
14. Carefully disconnect the Power Inlet wire from the wiring harness at
the Servo Motor.
Power Inlet
assembly
Flywheel cable
Engine wire harness
Servo Motor wire
Power wire
Speed/Direction
Sensor wire
Servo Motor
Power Inlet wire