General Operation
• Always use the cable supplied from your
Bowens dealer to connect the unit to the
mains power supply.
• It is recommended to switch on the Streamlite
a few minutes before you start shooting as the
light output will improve after the lamps have
been switched on for a short period.
• When operating the Streamlite angled down
more than 45° below horizontal, heat build up
can shorten the lamp life. If used this way limit
use to around 1 hour then switch off and allow
to cool before recommencing operation.
Replacing Lamps
• Switch OFF the power and disconnect from
the mains supply before removing / replacing
any lamps.
• Remove the reflector.
• While holding the lamp by the base, gently
screw the lamp into the lamp holder (as shown
in figure 1).
• Repeat previous step until all lamps are
positioned into the lamp holders (figure 2).
Attaching Reflector
• Position the spigots on the reflector into the
slots on the Streamlite (figure 3).
• Gently turn the reflector clockwise until locked
into place (figure 4).
Note: It is recommended that only lamps purchased
under a Bowens ‘BW’ stock code number are used as
replacements. The manufacturer will not accept liability
for the use of any other lamps.
6
-
Str
eamlite
|
Operation
Operation
figure 1.
figure 2.
figure 3.
figure 4.
Operation
Attaching Diffuser
• Place the diffuser over one side of the
reflector, as shown below.
• Stretch the elasticated diffuser over the
reflector until appears as shown.
Cocoon Stand Assembly
Step
ONE
- Place the two
leg sections on the floor
with the legs fully
extended.
Step
TWO
- Attach one of
the Cocoon Supports.
Use the studs on either
side of the support to
lock in place with the leg
sections.
Step
THREE
- Once the
studs are locked in place
the first support should
appear as shown.
Step
FOUR
- Attach both
supports to the legs.
Your assembled Cocoon
Stand should appear as
shown opposite.
Cocoon Assembly
Step
ONE
- Place the
central translucent panel
onto the floor with the
red and blue coloured
dots facing upwards.
Step
TWO
- Fasten the
two side panels using the
attached velcro. Ensure
coloured dots on each
panel line up to the
correct sides.
Step
THREE
- Attach the
final panel as shown.
Make sure all coloured
dots are correctly placed.
Step
FOUR
- Finally, zip
all of the panels together.
Your assembled Cocoon
should appear as shown.
Cocoon & Cocoon Stand Assembly
7
-
Str
eamlite
|
Operation
ONE
TWO
THREE
FOUR
ONE
TWO
THREE
FOUR