Bowens Octo 90, Owner'S Handbook, Page: 3 / 4

4
-
O
ct
o9
0
an
d
1
50
|
A
ss
em
b
ly
assembly assembly
Step ONE
Place the Octo90 (or Octo150) canopy (1) and the casting (2)
on the floor ready for assembly.
Step FOUR
After the hook and loop fastening strip is in place, pull the zip
up from the centre of the canopy towards the outer edge to
secure one side of the Octobox.
Step TWO
Place the casting in the centre of the canopy and insert all of
the rods into the casting as shown.
Step FIVE
Repeat steps three and four for the opposite side of the
Octobox. Your unit should appear as above. Ensure zip flaps
are seated on hook and loop fastening strips inside reflector.
Step THREE
Pull two sides together and hold them in place using the hook
and loop fastening strip (3) as indicated.
Step SIX
For optimum use (see page 6) connect the Octobox to a
support stand using the stand adaptor (4) as shown above
(ensure all thumb screws are fully tightened).
Step SEVEN
Connect the adjustment handle to the rear of the casting as
indicated above.
Step NINE
Pull the appropriate cabling (mains/sync lead) through the
cable slit (6) on the Octobox.
Step EIGHT
(Octo90 Only) Ensure the air vent (5) on the Octo90 is
positioned above the casting.
Step TEN
Connect your chosen flash unit to the casting and attach the
mains cable as shown above.
Step ELEVEN
Finally attach the diffuser to your Octobox. Your completed
unit should appear as above.
5
-
O
ct
o9
0
an
d
1
50
|
A
ss
em
b
ly
1
2
3
4
6
5